How to create a Bootable USB

 How to create a Bootable USB 

To create a bootable USB for windows 7 or windows 10 & 11, you need at least 4 GB USB drive. In the following steps you will learn the process

1. Insert your USB Driver into your computer or laptop

2. Go to Command Prompt and right click it and click run as administrator

3. you will see a screen as shown below:

type cd.. and press enter

again type cd.. and press enter

4. Type "Diskpart" without quotes and press enter, you see the below screen

5. Type "List disk" without quotes and press enter

here you will see all the disk attached with your computer including USB drive. The USB driver will be always the last drive as shown in above figure. 

6. Type "Select Disk 1" without quotes and press enter

7. Type " Clean" to clean all the data from your USB drive.

8. Type "Create partition primary" and press enter

9. Type " Select partition 1" and press enter

10. Type " Assign" and press enter

11. Type " Format fs= ntfs quick"  and press enter, This will format your USB drive

12. Type "exit" and you will come out of the Diskpart screen

13. Now Minimize the Command prompt screen

14. Go to the windows backup folder or CD Drive through command prompt and type the following

    "cd  D: press enter

     " cd windows 10 backup" and press enter

     " cd boot and press enter

     " type bootsect.exe/nt60 f: and press enter (F: is your USB drive letter and may be vary depending on your computer disks). 

after this command close the command prompt screen and go the folder where windows backup is placed and copy all the data and paste it in the USB drive. After copying your USB is now bootable and you can use it for windows installation.